Frank Short arms part II

MMT · Post by **MMT** » Wed Jun 25, 2003 5:22 pm

as of this mssg. I'm about 3 weeks away from a finished prototype. I like what I've pieced together so far. I shipped one out to a friend who is custom molding about 50 heads for me. I'll bend 'em myself. We'll have to get together to do a little R&D!

ukey28 · Post by **ukey28** » Fri Jun 27, 2003 2:15 am

Sounds Good!!
We can swap diaper stories during the r&d. Sounds like Shelter Island is in the future. Talk to you soon.
Frank

MMT · Post by **MMT** » Fri Jun 27, 2003 3:38 am

I'm in the process of making a tool to do the bends. Pretty much a template with nails to pull the wire around. Shouldn't be too hard.

brendanc · Post by **brendanc** » Tue Jul 01, 2003 2:41 pm

I want in... where do I sign?

ukey28 · Post by **ukey28** » Tue Jul 01, 2003 3:27 pm

Lets see, Craig mentioned start up costs for mold development at about 20K, wire design and form fabrication somewhere in the 10K range. Listening to Brendan ask in politely...... Priceless!!!

brendanc · Post by **brendanc** » Tue Jul 01, 2003 5:32 pm

Man, for someone who almost ended up fishing the Upper Mills during a "Forge Pond" tournament, you sure like to break 'em!

Keep it up and I'll get on the phone with the wife and let her know about your little trip to Niagra Falls...

(For those who were not there, just ignore this post, since it will not make any sense)

MMT · Post by **MMT** » Wed Jul 02, 2003 11:54 am

"for someone who almost ended up fishing the Upper Mills during a "Forge Pond" tournament, you sure like to break 'em!"

By the way, I know about this episode, thank God for the indestructable Minn Kota shaft!!!!

-OUCH
Bren, no soup for you!

Kidding, you're in! Maybe you'll get a few midnight specials out of the deal too!

ukey28 · Post by **ukey28** » Wed Jul 02, 2003 1:17 pm

I've got a new nickname "Spillway"

MMT · Post by **MMT** » Wed Jul 02, 2003 3:10 pm

I checked that area out today, man the water was just ripping, lucky you didn't get hurt